Category Archives: Auxiliary View

Auxillary View Definition – Where Did It Go?, by Brian McElyea

By admin | May 7, 2009

“If you create an auxillary view and then drag that view to a new sheet, the definition line gets hidden (I believe this is a bug – it should keep the definition shown by default). To turn it back on, …”  …
Keep Reading: Auxillary View Definition – Where Did It Go? | CADFanatic.
Published by [...]

Also posted in CADFanatic, Drawing | Tagged , , | Leave a comment

Making Intelligent Notes & Equations, by Brian McElyea

By admin | May 6, 2009

“When calling out holes on drawings, best engineering practices are to dimension holes in true profile views. SolidWorks will only let you place place hole notes on arcs. But sometimes on a complicated drawing, creating an extra auxiliary view just to show a hole callout is not desired and can really clutter the [...]

Also posted in Annotation, CADFanatic, Dimensions/Relations, Drawing, Equations, Hole Callout, Note | Tagged , , , , | Leave a comment